RADIO ANTENNA CORD REMOVAL


  1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY

    Click here

  2. REMOVE NO. 3 HEATER TO REGISTER DUCT (for LHD)


    1. A01EWLE

      Remove the clip.

    2. Remove the 3 screws <C> and No. 3 heater to register duct.

  3. REMOVE HEATER TO REGISTER DUCT ASSEMBLY (for RHD)


    1. A01EUK2

      Remove the clip.

    2. Remove the 3 screws <C>.

    3. Disengage the heater to register duct assembly from the ion generator assembly, to remove the heater to register duct.

  4. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT


    1. A01EY3H

      Remove the screw <C>.

    2. Disengage the 2 claws to remove the No. 2 side defroster nozzle duct.

  5. REMOVE ANTENNA CORD SUB-ASSEMBLY (for LHD)


    1. Disengage the 8 clamps and remove the antenna cord sub-assembly.

      A01EWF8

  6. REMOVE ANTENNA CORD SUB-ASSEMBLY (for RHD)


    1. Disengage the 10 clamps and remove the antenna cord sub-assembly.

      A01EZ0F

  7. REMOVE ROOF HEADLINING ASSEMBLY

    Click here

  8. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY


    1. Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.

      Tech Tips

      Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.

    2. Remove the No. 2 antenna cord sub-assembly from the roof headlining.

      A01EW4RE01
      Text in Illustration
      *A w/o Sliding Roof *B w/ Sliding Roof
      *1 Tape - -
      *a Front - -