FRONT WIPER MOTOR REMOVAL


  1. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    1. A01EWYC

      Remove the nut and front wiper arm and blade assembly LH.

  2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH


    1. A01EYRN

      Remove the nut and front wiper arm and blade assembly RH.

  3. REMOVE FRONT FENDER TO COWL SIDE SEAL LH


    1. A01EY1L

      Disengage the 2 clips and 3 guides, and remove the front fender to cowl side seal LH as shown in the illustration.

  4. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

    Tech Tips

    Use the same procedure as for the LH side.

  5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    1. Disengage the 6 claws and guide as shown in the illustration.

      A01EYY1

    2. Disengage the 8 guides and pull out the cowl top ventilator louver sub-assembly as shown in the illustration.

      A01EUCF

  6. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for LHD)


    1. Operate the wiper and stop the windshield wiper motor at the automatic stop position.

    2. A01EWR3E02
      Text in Illustration
      *1 Motor Grommet

      Disconnect the connector.

    3. Remove the 2 bolts.

    4. Disengage the motor grommet and remove the windshield wiper motor and link assembly as shown in the illustration.

      Note

      Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.

  7. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD)


    1. Operate the wiper and stop the windshield wiper motor at the automatic stop position.

    2. A01EYHYE01
      Text in Illustration
      *1 Motor Grommet

      Disengage the 2 clamps and then disconnect the connector.

    3. Remove the 2 bolts.

    4. Disengage the motor grommet and remove the windshield wiper motor and link assembly as shown in the illustration.

      Note

      Be careful not to damage the windshield when removing the windshield wiper motor and link assembly.

  8. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    1. A01EWSTE02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, separate the No. 1 rod from the windshield wiper motor assembly as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01EX6H

      Using a T30 "TORX" socket wrench, remove the 2 bolts and windshield wiper motor assembly from the wiper link assembly.