TILT AND TELESCOPIC MANUAL SWITCH INSTALLATION


  1. INSTALL TILT AND TELESCOPIC SWITCH


    1. Engage the claw to install the tilt and telescopic switch.

    2. Connect the connector.

  2. INSTALL LOWER STEERING COLUMN COVER


    1. A01EWTM

      Engage the 2 claws to install the lower steering column cover.

    2. A01ETMW

      Install the 3 screws.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

  3. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Note

    Do not adjust the spiral cable sub-assembly with the battery connected and the ignition switch to ON.


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01ESRUE01

      Check if the spiral cable sub-assembly is centered.

      Text in Illustration
      A01EUW4 Colored Part

      Tech Tips

      When the spiral cable sub-assembly is centered, the part indicated by A is positioned at the top and the colored part shown in the illustration is visible.

    4. If the spiral cable sub-assembly is not centered, center it.

      Note


      • When rotating the spiral cable sub-assembly, make sure to push on the interlock indicated in the illustration to release the interlock mechanism.

      • Do not turn the spiral cable sub-assembly using the airbag wire harness.


      1. A01ETN4

        While pushing on the interlock indicated in the illustration, rotate the spiral cable sub-assembly counterclockwise slowly by hand until it stops.

        Text in Illustration
        A01EV1N Interlock
      2. A01EY26

        Rotate the spiral cable sub-assembly clockwise approximately 2.5 turns to the position where the colored part shown in the illustration is visible.

        Text in Illustration
        A01EUW4 Colored Part
        A01EV1N Interlock

        Tech Tips

        The spiral cable sub-assembly will rotate approximately 2.5 turns to both the left and right from the center.

  4. INSTALL STEERING WHEEL ASSEMBLY


    1. A01ETA1E01
      Text in Illustration
      *a Matchmark

      Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.

    2. Install the steering wheel assembly set nut.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

    3. Connect the connectors to the spiral cable sub-assembly.

  5. INSTALL STEERING PAD

    Click here