STEERING WHEEL REMOVAL

Note


  • Do not replace the spiral cable with the battery connected and the ignition switch ON.

  • Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch ON.

  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.


  1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  2. REMOVE HORN BUTTON ASSEMBLY

    Click here

  3. REMOVE STEERING WHEEL ASSEMBLY


    1. A01ETA1E01
      Text in Illustration
      *a Matchmark

      Remove the steering wheel assembly set nut.

    2. Put matchmarks on the steering wheel assembly and steering main shaft.

    3. Disconnect the connectors from the spiral cable sub-assembly.

    4. A01EVJQE01
      Text in Illustration
      *a Turn
      *b Hold

      Using SST, remove the steering wheel assembly.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05070 )

      Note

      Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.

  4. REMOVE STEERING PAD SWITCH ASSEMBLY


    1. Disconnect the steering pad switch connector from the spiral cable sub-assembly.

    2. w/ Shift Paddle Switch Wire of Steering Pad Switch Assembly:


      1. A01EVRG

        Disengage the clamp.

    3. A01ET4ZE01
      Text in Illustration
      *1 Pin
      *2 Guide

      Remove the 2 screws.

    4. Disengage the 2 claws, 2 pins and 2 guides to remove the steering pad switch assembly.

  5. REMOVE CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)


    1. A01EWI3

      Remove the 2 screws.

    2. A01EW54

      Disconnect the connector and remove the cruise control main switch.

  6. REMOVE CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)


    1. Remove the cruise control switch wire.

  7. REMOVE STEERING SHAKE DAMPER


    1. A01ESTP

      Remove the 2 screws and steering shake damper from the steering wheel sub-assembly.