BRAKE BOOSTER (for LHD) REMOVAL

Note

Make sure to release vacuum from the brake booster assembly before removing the brake master cylinder sub-assembly from the brake booster assembly.


  1. REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY

    Click here

  2. SEPARATE NO. 1 HOSE TO HOSE TUBE (for 2AR-FE)


    1. A01EVH9

      Slide the clip and disconnect the No. 1 hose to hose tube from the brake booster assembly.

    2. Remove the 2 nuts to separate the No. 1 hose to hose tube from the vehicle body.

  3. REMOVE NO. 1 HOSE TO HOSE TUBE (for 1AZ-FE)

    Tech Tips

    Use the same procedure for 2AR-FE.

  4. DISCONNECT UNION TO CHECK VALVE HOSE (for 2GR-FE)


    1. A01ET6F

      Slide the clip and disconnect the union to check valve hose from the brake booster assembly.

  5. REMOVE PUSH ROD PIN


    1. A01ETZZ

      Remove the clip and push rod pin.

    2. Separate the brake master cylinder push rod clevis from the brake pedal support assembly.

  6. REMOVE BRAKE BOOSTER ASSEMBLY


    1. A01ESXQ

      Remove the 4 nuts and brake booster assembly from the vehicle body.

      Note

      Do not kink or damage the brake lines.

  7. REMOVE BRAKE BOOSTER GASKET


    1. A01EXSV

      Remove the brake booster gasket from the brake booster assembly.

  8. REMOVE BRAKE MASTER CYLINDER PUSH ROD CLEVIS


    1. Loosen the lock nut and remove the brake master cylinder push rod clevis and lock nut from the brake booster assembly.

  9. REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY


    1. Remove the brake vacuum check valve assembly from the brake booster assembly.

  10. REMOVE CHECK VALVE GROMMET


    1. Remove the check valve grommet from the brake booster assembly.