FRONT LOWER SUSPENSION ARM (for 2GR-FE) INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY


    1. Install the front lower arm bushing stopper to the front lower No. 1 suspension arm sub-assembly.

    2. A01ETG8E01

      Install the front lower No. 1 suspension arm sub-assembly to the front frame assembly with the 3 bolts and nut in the order shown in the illustration.

      Torque:
      Bolt 1, 2
      200 N*m  { 2039 kgf*cm, 148 ft.*lbf }
      Bolt 3
      135 N*m  { 1377 kgf*cm, 100 ft.*lbf }

      Note

      While keeping the nut from rotating, tighten the bolt.

  2. INSTALL ENGINE MOUNTING INSULATOR


    1. Temporarily install the engine mounting insulator LH with the 3 bolts.

      Tech Tips

      Perform this procedure only when replacement of the engine mounting insulator LH is necessary.

  3. INSTALL FRONT FRAME ASSEMBLY

    Click here