PARK / NEUTRAL POSITION SWITCH ADJUSTMENT


  1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Remove the transmission control shaft lever Click here.

    2. A01EV6M

      Loosen the bolts of the park/neutral position switch assembly.

    3. A01ET9WE02
      Text in Illustration
      *a Nut Stopper Protrusion
      *b Neutral Basic Line

      Align the nut stopper protrusion with the neutral basic line.

    4. Hold the park/neutral position switch assembly in position and tighten the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Note

      After installing the park/neutral position switch assembly, confirm that the nut stopper protrusion and neutral basic line on the switch are aligned.

    5. Install the transmission control shaft lever Click here.

    6. After the adjustment, perform the switch operation check Click here.