PARK / NEUTRAL POSITION SWITCH REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01EX8D

      Remove the 2 nuts and No. 1 engine cover sub-assembly.

  4. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01EX2B

      Remove the 9 clips and cool air intake duct seal.

  5. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A01EVXG

      Remove the 2 bolts and inlet air cleaner assembly.

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01EV7D

      Disconnect the vacuum switching valve connector.

    2. Disconnect the 2 vacuum switching valve vacuum hoses.

    3. Disconnect the purge line hose from the 2 clamps.

    4. Disconnect the mass air flow meter connector.

    5. Disconnect the wire harness clamp.

    6. Loosen the 2 bolts and separate the air cleaner cap sub-assembly.

    7. A01EW34

      Disconnect the ventilation hose from the cylinder head cover sub-assembly.

    8. A01EX2PE01
      Text in Illustration
      *1 Air Cleaner Hose Clamp

      Lock the air cleaner hose clamp as shown in the illustration, and disconnect the air cleaner cap sub-assembly from the throttle with motor body assembly.

    9. Remove the air cleaner filter element from the air cleaner case sub-assembly.

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01ESTN

      Disconnect the wire harness clamp.

    2. Remove the 3 bolts and air cleaner case sub-assembly.

  8. REMOVE BATTERY


    1. Loosen the nut, and disconnect the cable from the positive (+) battery terminal.

    2. A01EYK4

      Loosen the nut, and remove the bolt and battery clamp.

    3. Remove the battery from the battery tray.

  9. REMOVE BATTERY TRAY


    1. Remove the battery tray from the body.

  10. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. Move the shift lever to N.

    2. A01EU2LE01

      Disconnect the connector from the park/neutral position switch assembly.

    3. A01EYI2

      Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

    4. Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

    5. A01ET7Z

      Remove the nut, washer and control shaft lever from the manual valve lever shaft sub-assembly.

    6. A01EVVN

      Pry out the lock plate and remove the nut and lock plate from the manual valve lever shaft sub-assembly.

    7. A01EV6M

      Remove the 2 bolts and pull out the park/neutral position switch assembly from the manual valve lever shaft sub-assembly.