STARTER INSTALLATION


  1. INSTALL STARTER ASSEMBLY


    1. Install the starter assembly with the 2 bolts.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. Connect the starter connector.

    3. Install the terminal nut and cover the nut with the cap.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

  2. INSTALL AIR CLEANER CASE SUB-ASSEMBLY


    1. A01EUCHE01
      Text in Illustration
      *1 Air Cleaner Case Sub-assembly
      *2 Inlet No. 1 Air Cleaner
      *a Projection
      *b Hole

      Install the air cleaner case sub-assembly to the inlet No. 1 air cleaner.

    2. Insert the projection of the air cleaner case sub-assembly to the hole of the No. 2 air cleaner bracket as shown in the illustration.

    3. Tighten the 2 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    4. Connect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.

  3. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    1. Connect the air cleaner cap sub-assembly to the throttle with motor body assembly with the hose clamp.

    2. Install the air cleaner cap with hose to the air cleaner case with the 2 clamps.

    3. Connect the wire harness clamp and mass air flow meter connector.

    4. Connect the 3 hoses.

    5. Connect the ventilation hose.

    6. Connect the mass air flow meter connector and wire harness clamp.

  5. INSTALL INLET NO. 1 AIR CLEANER


    1. A01EWYZ

      Install the inlet No. 1 air cleaner to the intake air resonator sub-assembly.

    2. Engage the pin to the radiator support.

  6. INSTALL BATTERY


    1. Install the battery and battery tray.

    2. Install the battery clamp with the bolt and nut.

      Torque:
      Bolt
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }
      Nut
      3.5 N*m  { 36 kgf*cm, 31 in.*lbf }

    3. Connect the positive (+) cable to the positive (+) battery terminal.

      Torque:
      6.5 N*m  { 66 kgf*cm, 58 in.*lbf }

  7. INSTALL INLET NO. 2 AIR CLEANER


    1. Install the inlet No. 2 air cleaner to the air cleaner case sub-assembly with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

    2. Connect the 2 wire harness clamps and vacuum hose clamp.

  8. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. Fit the 3 retainers and install the V-bank cover sub-assembly.

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 9 clips.