STARTER REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01EX2B

      Remove the 9 clips and cool air intake duct seal.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE V-BANK COVER SUB-ASSEMBLY


    1. A01EXXK

      Hold the front of the V-bank cover sub-assembly and raise it to disengage the 2 retainers on the front of the V-bank cover sub-assembly. Continue to raise the V-bank cover sub-assembly to disengage the retainer on the rear of the V-bank cover sub-assembly and remove the V-bank cover sub-assembly.

      Note

      Attempting to disengage both front and rear retainers at the same time may cause the V-bank cover sub-assembly to break.

  5. REMOVE INLET NO. 2 AIR CLEANER


    1. A01ETT7

      Disconnect the 2 wire harness clamps and vacuum hose clamp.

    2. Remove the 2 bolts and inlet No. 2 air cleaner.

  6. REMOVE BATTERY


    1. A01EY5S

      Disconnect the positive (+) cable from the positive (+) battery terminal.

    2. Loosen the nut and remove the bolt.

    3. Remove the battery and battery tray.

  7. REMOVE INLET NO. 1 AIR CLEANER


    1. A01ETN6

      Disengage the pin and remove the inlet No. 1 air cleaner.

  8. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01EYE1

      Disconnect the mass air flow meter connector and wire harness clamp.

    2. A01EX8F

      Disconnect the 3 hoses.

    3. Separate the ventilation hose.

    4. A01EV6T

      Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.

    5. Release the 2 clamps and remove the air cleaner cap with hose.

  9. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  10. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01ET8O

      Disconnect the wire harness clamp, connector, vacuum hose and No. 1 fuel vapor feed hose.

    2. Remove the 2 bolts and air cleaner case sub-assembly.

  11. REMOVE STARTER ASSEMBLY


    1. A01EV5Y

      Disconnect the starter connector.

    2. Remove the terminal cap.

    3. Remove the nut and disconnect the starter wire.

    4. A01ET1Y

      Remove the 2 bolts and starter assembly.