OIL PRESSURE SWITCH INSTALLATION


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. A01EWGLE15
      Text in Illustration
      *1 Adhesive

      Apply adhesive to 2 or 3 threads of the oil pressure switch.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    2. Using a deep socket wrench, install the oil pressure switch.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installation.

    3. Connect the connector.

  2. INSPECT FOR OIL LEAK

  3. INSPECT ENGINE OIL LEVEL


    1. Warm up the engine, stop it and wait 5 minutes. The oil level should be between the engine oil level dipstick low level mark and full level mark.

      If the engine oil level is low, check for leakage and add oil up to the full level mark.

      Note

      Do not add engine oil to above the full level mark.