STARTER REMOVAL


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01EX2B

      Remove the 9 clips and cool air intake duct seal.

  4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01EX8D

      Remove the 2 nuts and No. 1 engine cover sub-assembly.

  5. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A01EVXG

      Remove the 2 bolts and inlet air cleaner assembly.

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01EV9K

      Disconnect the connector and wire harness clamp from the air cleaner cap sub-assembly.

    2. Loosen the hose clamp and disconnect the air cleaner cap sub-assembly from the air cleaner hose.

    3. Remove the 2 bolts and air cleaner cap sub-assembly.

  7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01ESTN

      Disconnect the wire harness clamp.

    2. Remove the 3 bolts and air cleaner case sub-assembly.

  9. REMOVE STARTER ASSEMBLY


    1. A01EWZN

      Disconnect the connector.

    2. Open the terminal cap, remove the nut and disconnect the starter wire.

    3. A01EYMU

      Remove the 2 bolts and starter assembly.