OIL PUMP REMOVAL

Note

Do not remove the oil pump or oil pump relief valve from the timing chain cover sub-assembly.


  1. REMOVE ENGINE AND TRANSAXLE

    Click here

  2. REMOVE ENGINE WIRE

  3. REMOVE IGNITION COIL ASSEMBLY


    1. Disconnect the 4 ignition coil assembly connectors.

    2. A01EY1F

      Remove the 4 bolts and 4 ignition coil assemblies.

  4. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY


    1. A01EURE

      Remove the 16 bolts, 3 seal washers, cylinder head cover and gasket.

    2. A01EV5L

      Remove the 3 gaskets from the camshaft bearing caps.

  5. REMOVE CRANKSHAFT POSITION SENSOR

  6. REMOVE CRANKSHAFT PULLEY


    1. A01EV04E05
      Text in Illustration
      *a Hold
      *b Turn

      Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.

      SST
      09213-54015
      09330-00021

      Tech Tips

      SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)

    2. A01EURHE02
      Text in Illustration
      *1 Pulley Bolt
      *a Hold
      *b Turn

      Using SST and the pulley bolt, remove the crankshaft pulley.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05011 )

      Tech Tips

      Apply a lubricant to the threads and end of SST.

  7. REMOVE ENGINE MOUNTING BRACKET RH


    1. A01EY7I

      Remove the 5 bolts and engine mounting bracket RH.

  8. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY


    1. A01EWOV

      Remove the bolt and V-ribbed belt tensioner.

  9. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY


    1. A01ET7M

      Remove the 17 bolts and 2 nuts.

    2. A01EX2V

      Remove the timing chain cover by prying between the timing chain cover and cylinder head, camshaft housing, cylinder block and stiffening crankcase with a screwdriver as shown in the illustration.

      Note

      Be careful not to damage the contact surfaces of the cylinder head, camshaft housing, cylinder block, stiffening crankcase or chain cover.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A01ETJC

      Remove the 3 gaskets from the stiffening crankcase.

  10. REMOVE TIMING CHAIN COVER OIL SEAL


    1. A01EX4DE04
      Text in Illustration
      *1 Wooden Block

      Using a screwdriver and wooden block, pry out the oil seal.

      Note

      Do not damage the surface of the oil seal press fit hole.

      Tech Tips

      Tape the screwdriver tip before use.