OIL PRESSURE SWITCH INSTALLATION


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. A01EWGLE08
      Text in Illustration
      *1 Adhesive

      Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

    2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour of installation.

    3. Connect the engine oil pressure switch connector.

  2. INSTALL AIR CLEANER CASE SUB-ASSEMBLY


    1. Install the air cleaner case sub-assembly with the 3 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    2. Connect the wire harness clamp.

  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    1. Install the air cleaner filter element to the air cleaner case sub-assembly.

    2. A01EWNAE01
      Text in Illustration
      *1 Air Cleaner Hose Clamp

      Connect the air cleaner cap sub-assembly to the throttle with motor body assembly and release the lock of the air cleaner hose clamp.

      Note


      • Align the groove of the air cleaner cap sub-assembly with the tab of the throttle with motor body assembly and install the hose.

      • Make sure that the tab of the air cleaner hose clamp stays within the range shown by *a.

    3. Connect the ventilation hose to the cylinder head cover.

    4. Install the air cleaner cap sub-assembly and tighten the 2 bolts.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    5. Connect the wire harness clamp.

    6. Connect the mass air flow meter connector.

    7. Connect the purge line hose to the 2 clamps.

    8. Connect the 2 vacuum switching valve vacuum hoses.

    9. Connect the vacuum switching valve connector.

  4. INSTALL INLET AIR CLEANER ASSEMBLY


    1. Install the inlet air cleaner assembly with the 2 bolts.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  5. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 9 clips.

  6. INSPECT FOR OIL LEAK