EXHAUST MANIFOLD REMOVAL


  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

  2. REMOVE ENGINE UNDER COVER RH

  3. REMOVE RADIATOR RESERVE TANK ASSEMBLY


    1. A01EW5Z

      Disconnect the radiator reserve tank hose.

    2. Remove the 2 bolts and radiator reserve tank assembly.

  4. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Front Side)


    1. A01EV1P

      Remove the 2 nuts and No. 1 exhaust pipe support bracket (for Front Side).

  5. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. A01EVXI

      Disconnect the 2 wire harnesses from the clamp.

    2. Disconnect the 2 heated oxygen sensor connectors.

    3. A01EW1N

      Remove the 2 bolts and No. 1 exhaust pipe support bracket (for Rear Side).

    4. A01ETCT

      Remove the 4 bolts, 4 nuts and front exhaust pipe assembly.

    5. Remove the 3 gaskets from the front exhaust pipe assembly.

  6. REMOVE AIR FUEL RATIO SENSOR (for Bank 1)


    1. A01EVNP

      Disconnect the air fuel ratio sensor connector.

    2. Disconnect the harness clamp.

    3. A01EU93E01

      Using SST, remove the air fuel ratio sensor from the exhaust manifold RH.

      SST
      09224-00010

  7. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH


    1. A01EUZR

      Using a 12 mm deep socket wrench, remove the 6 nuts and exhaust manifold sub-assembly RH.

    2. A01EYEJ

      Remove the gasket from the cylinder head sub-assembly.

  8. REMOVE AIR FUEL RATIO SENSOR (for Bank 2)


    1. A01ETRJ

      Disconnect the air fuel ratio sensor connector.

    2. A01EW6W

      Separate the wire harness clamp.

    3. A01ESVVE01

      Using SST, remove the air fuel ratio sensor from the exhaust manifold LH.

      SST
      09224-00010

  9. REMOVE NO. 2 ENGINE OIL LEVEL DIPSTICK GUIDE


    1. A01EUZV

      Remove the oil level dipstick.

    2. Remove the bolt and No. 2 engine oil level dipstick guide.

    3. A01EV7G

      Remove the O-ring from the No. 2 engine oil level dipstick guide.

  10. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    1. A01EXM4

      Remove the 3 bolts and No. 2 exhaust manifold heat insulator.

  11. REMOVE NO. 2 MANIFOLD STAY


    1. A01EXRW

      Remove the bolt, nut and No. 2 manifold stay.

  12. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH


    1. A01EYQ5

      Using a 12 mm deep socket wrench, remove the 6 nuts and exhaust manifold sub-assembly LH.

    2. A01ET0W

      Remove the gasket from the cylinder head sub-assembly.