SLIDING ROOF SWITCH ASSEMBLY INSPECTION


  1. INSPECT SLIDING ROOF SWITCH (ROOF CONSOLE BOX ASSEMBLY)


    1. A01EXG9E01
      Text in Illustration
      *a

      Component without harness connected

      (Sliding Roof Switch (Roof Console Box Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      6 (UP) - 10 (GND) UP switch is pressed Below 1 Ω
      6 (UP) - 10 (GND) UP switch is not pressed 10 kΩ or higher
      7 (DOWN) - 10 (GND) DOWN switch is pressed Below 1 Ω
      7 (DOWN) - 10 (GND) DOWN switch is not pressed 10 kΩ or higher
      8 (OPN) - 10 (GND) OPEN switch is pressed Below 1 Ω
      8 (OPN) - 10 (GND) OPEN switch is not pressed 10 kΩ or higher
      9 (CLS) - 10 (GND) CLOSE switch is pressed Below 1 Ω
      9 (CLS) - 10 (GND) CLOSE switch is not pressed 10 kΩ or higher

      If the result is not as specified, replace the sliding roof switch (roof console box assembly).