PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable from the negative (-) battery terminal, initialize the following system after the cable is reconnected.
| System Name | See Procedure |
|---|---|
| Parking Assist Monitor System |
IGNITION SWITCH EXPRESSIONS
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition Switch off | LOCK | Off |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | Start |
PRECAUTIONS WHEN USING INTELLIGENT TESTER
When using the intelligent tester with the ignition switch off to troubleshoot: Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5 second or less intervals until communication between the intelligent tester and vehicle begins.
After all DTCs are cleared, check if the trouble occurs again 6 seconds after turning the ignition switch to ON.