ROOF HEADLINING DISASSEMBLY


  1. REMOVE VANITY LIGHT ASSEMBLY


    1. Remove the vanity light assembly Click here.

      Tech Tips

      Use the same procedure for the other vanity light.

  2. REMOVE NO. 1 ROOF SILENCER PAD (w/o Sliding Roof)


    1. Remove the 3 No. 1 roof silencer pads.

      A01EV7M

  3. REMOVE NO. 2 ROOF SILENCER PAD (w/o Sliding Roof)


    1. Remove the No. 2 roof silencer pad.

      A01EY4F

  4. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY


    1. Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.

      Tech Tips

      Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.

    2. Remove the No. 2 antenna cord sub-assembly from the roof headlining.

      A01EW4RE01
      Text in Illustration
      *A w/o Sliding Roof *B w/ Sliding Roof
      *1 Tape - -
      *a Front - -

  5. REMOVE NO. 1 ROOF WIRE


    1. Remove the adhesive tape from the roof headlining assembly.

      A01ETIGE01
      Text in Illustration
      *A w/o Sliding Roof *B w/ Sliding Roof
      *C w/o Rain Sensor *D for LHD with Rain Sensor
      *E for RHD with Rain Sensor - -
      *1 Adhesive Tape - -

    2. Turn the visor connectors counterclockwise approximately 45° and separate the connectors from the roof headlining assembly.

    3. Remove the No. 1 roof wire from the roof headlining assembly.

      A01EVLJE01
      Text in Illustration
      *A w/o Sliding Roof *B w/ Sliding Roof