OUTER REAR VIEW MIRROR GLASS INSPECTION


  1. INSPECT OUTER MIRROR RH


    1. Check the shape of the heater wire.

    2. Check the outer mirror heater operation.

      A01EWSSE01

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Heater Wire Shape A
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 7.6 to 11.4 Ω
        Heater Wire Shape B
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 9.2 to 13.8 Ω
        Text in Illustration
        *A Heater Wire Shape A *B Heater Wire Shape B
        *a

        Component without harness connected

        (Outer Mirror RH)

        		 *b Heater Wire

        If the result is not as specified, replace the outer mirror RH.

    3. Check the operation of the outer rear view mirror indicator (w/ Blind Spot Monitor System).

      Note

      Do not apply a voltage of more than 6 V.


      1. Connect 4 new 1.5 V dry-cell batteries in series.

      2. A01ESRWE01
        Text in Illustration
        *a

        Component without harness connected

        (Outer Mirror RH)

        Apply 6 V battery voltage to the terminals of the connector, and check that the outer rear view mirror indicator comes on.

        OK
        Tester Connection Specified Condition

        6 V battery positive (+) → Terminal 2

        6 V battery negative (-) → Terminal 1

        		 Outer rear view mirror indicator comes on

        If the result is not as specified, replace the outer mirror RH.

  2. INSPECT OUTER MIRROR LH


    1. Check the shape of the heater wire.

    2. Check the outer mirror heater operation.

      A01EWFQE01

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Heater Wire Shape A
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 7.6 to 11.4 Ω
        Heater Wire Shape B
        Tester Connection Condition Specified Condition
        1 - 2 25°C (77°F) 9.2 to 13.8 Ω
        Text in Illustration
        *A Heater Wire Shape A *B Heater Wire Shape B
        *a

        Component without harness connected

        (Outer Mirror LH)

        		 *b Heater Wire

        If the result is not as specified, replace the outer mirror LH.

    3. Check the operation of the outer rear view mirror indicator (w/ Blind Spot Monitor System).

      Note

      Do not apply a voltage of more than 6 V.


      1. Connect 4 new 1.5 V dry-cell batteries in series.

      2. A01EU62E01
        Text in Illustration
        *a

        Component without harness connected

        (Outer Mirror LH)

        Apply 6 V battery voltage to the terminals of the connector, and check that the outer rear view mirror indicator comes on.

        OK
        Tester Connection Specified Condition

        6 V battery positive (+) → Terminal 2

        6 V battery negative (-) → Terminal 1

        		 Outer rear view mirror indicator comes on

        If the result is not as specified, replace the outer mirror LH.