OUTER REAR VIEW MIRROR GLASS REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.


  1. REMOVE OUTER MIRROR (w/o Memory)


    1. A01EVFZE04
      Text in Illustration
      *a Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. Push the upper part of the mirror surface and tilt it.

    3. A01EU6GE03
      Text in Illustration
      *a Moulding Remover

      Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.

    4. A01EXC8

      Disengage the 2 guides as shown in the illustration.

    5. A01EWE0

      Disconnect the 2 connectors and remove the outer mirror.

  2. REMOVE OUTER MIRROR (w/ Memory)


    1. A01EXA1E01
      Text in Illustration
      *a Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. Push the upper part of the mirror surface and tilt it.

    3. Using a moulding remover, disengage the 2 claws at the lower part of the outer mirror as shown in the illustration.

    4. A01EV6OE01
      Text in Illustration
      *a Protective Tape

      Apply protective tape to the area shown in the illustration.

    5. Push the lower part of the mirror surface and tilt it.

    6. Using a moulding remover, disengage the 2 claws at the upper part of the outer mirror as shown in the illustration.

    7. A01EW90E01
      *a Mirror Heater Connector
      *b Blind Spot Monitor Indicator Connector

      Disconnect the mirror heater connector.

    8. Disengage the 2 claws.

    9. Using a screwdriver, release the tabs of the blind spot monitor indicator connector to disconnect the connector and remove the outer mirror.

      Note


      • Do not bend the tabs excessively to prevent them from being damaged.

      • If the tabs are damaged, replace the outer mirror with a new one.