OUTER REAR VIEW MIRROR REMOVAL

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


    1. A01EW9K

      Using a moulding remover, disengage the 3 claws and remove the front door inside handle bezel plug as shown in the illustration.

  2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH


    1. A01EWAK

      Disengage the 3 clips and remove the front door lower frame bracket garnish.

  3. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


    1. A01ET0S

      Using a moulding remover, disengage the 2 clips, 5 claws and 4 guides as shown in the illustration.

    2. Disconnect each connector and remove the multiplex network master switch assembly with front door armrest base panel.

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


    1. A01EVT3

      Using a moulding remover, disengage the 2 clips, 5 claws and 4 guides as shown in the illustration.

    2. Disconnect the connector and remove the power window regulator switch assembly with front door armrest base panel.

  5. REMOVE FRONT ARMREST ASSEMBLY


    1. A01ETHV

      Using a moulding remover, disengage the 3 clips, 7 claws and 2 guides and remove the front armrest assembly.

  6. REMOVE COURTESY LIGHT ASSEMBLY


    1. A01EYPHE01
      Text in Illustration
      *A for LH Side
      *B for RH Side
      *1 Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disengage the claw.

    2. Disconnect the connector and remove the courtesy light assembly.

  7. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


    1. A01EYW5E01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front door panel.

    2. A01EUAW

      Remove the 3 screws.

    3. Using a clip remover, disengage the 10 clips.

    4. A01EXOZE01
      Text in Illustration
      *1 Reference Boss
      *2 Front Door Inner Glass Weatherstrip

      Pull out the front door trim board sub-assembly in the direction indicated by the arrow as shown in the illustration.

    5. Disengage the reference boss from the front door panel.

    6. Raise the front door trim board sub-assembly to remove the front door trim board sub-assembly together with the front door inner glass weatherstrip.

    7. Disconnect the connector.

    8. A01ESQ6

      Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly.

  8. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP


    1. A01EYR5E01
      Text in Illustration
      *1 Screwdriver

      Using a screwdriver, disengage the 4 claws and remove the front door inner glass weatherstrip from the front door trim board sub-assembly as shown in the illustration.

  9. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY


    1. A01EUFH

      Disconnect the connector.

    2. Remove the 3 bolts.

    3. Disengage the claw and remove the outer rear view mirror assembly.