SFI SYSTEM PRECAUTION


  1. INITIALIZATION

    Note


    • If the ECM is replaced, register the ECU communication ID for Engine Immobiliser System (w/o Smart Entry and Start System) (Refer to the Service Bulletin for Registration).

    • Make sure to perform Reset Memory (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM Click here.

    • Perform Registration (VIN registration) when replacing the ECM Click here.

    • When the cable is disconnected from the negative (-) battery terminal, initialize the following system after the cable is reconnected.

      System Name See Procedure
      Parking Assist Monitor System

      Click here

    Tech Tips

    Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.

  2. WHEN USING GTS

    CAUTION:

    Observe the following items for safety reasons:


    • Before using the GTS, read the instruction manual.

    • Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

    • When driving the vehicle for testing purposes using the GTS, 2 persons are required. One is for driving the vehicle, and the other operates the GTS.

  3. IGNITION SWITCH EXPRESSIONS

    Tech Tips

    The type of ignition switch used on this model differs according to the specifications of the vehicle.

    The expressions listed in the table below are used in this section.

    Expression Ignition Switch (Position) Engine Switch (Condition)
    Ignition switch off LOCK Off
    Ignition switch ON ON On (IG)
    Ignition switch ACC ACC On (ACC)
    Engine Start START Start