FUEL INJECTOR REMOVAL

Tech Tips

Perform "Inspection After Repair" after replacing the fuel injector assembly Click here.


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE INTAKE AIR SURGE TANK ASSEMBLY

    Click here

  5. DISCONNECT FUEL TUBE SUB-ASSEMBLY


    1. A01ETPSE09
      Text in Illustration
      *1 No. 2 Fuel Pipe Clamp
      *2 Fuel Tube Connector
      *3 Nylon Tube
      *4 O-ring
      *5 Fuel Pipe
      A01EUL1 Pinch
      A01ETOA Pull

      Remove the No. 2 fuel pipe clamp.

    2. Pinch the tube connector and pull out the fuel pipe.

      Note


      • Check that there is no dirt or other foreign objects around the fuel tube connector when disconnecting it. Clean the fuel tube connector as necessary.

      • It is necessary to prevent dirt or foreign objects from entering the fuel tube connector. If dirt or foreign objects get in the fuel tube connector, the O-rings may not seal properly.

      • Only disconnect the fuel tube connector by hand.

      • Do not bend, kink or twist the nylon tubes.

      • Protect the fuel tube connector by covering it with a plastic bag.

      • If the fuel pipe and the fuel tube connector are stuck, carefully try wiggling or pushing and pulling on the fuel tube connector to release it. Pull the fuel tube connector off carefully.

  6. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY


    1. A01EU92

      Disconnect the 6 fuel injector connectors.

    2. A01EXCK

      Remove the 5 bolts and fuel delivery pipe sub-assembly together with the 6 fuel injectors.

      Note

      Be careful not to drop the fuel injectors when removing the fuel delivery pipe.

    3. A01EZ4AE01

      Remove the 6 injector vibration insulators from the intake manifold.

  7. REMOVE FUEL INJECTOR ASSEMBLY


    1. A01ETO5

      Pull the 6 fuel injector assemblies out of the fuel delivery pipe sub-assembly.

      Note

      If the injectors are to be reused, reinstall them to the same cylinder they came from.

    2. A01ETZYE03
      Text in Illustration
      *1 O-ring

      Remove the O-ring from each fuel injector assembly.

    3. For reinstallation, attach a tag or label to each injector shaft.

      Note

      Prevent entry of foreign matter by covering the fuel injectors with plastic bags.