DRIVE BELT INSTALLATION


  1. INSTALL V-RIBBED BELT


    1. A01EVBHE02
      Text in Illustration
      *1 Water Pump
      *2 Idler
      *3 Generator
      *4 Crankshaft
      *5 Tensioner
      *6 A/C Compressor

      Install the V-ribbed belt.

    2. A01EYOL

      Turn the V-ribbed belt tensioner counterclockwise and remove the 5 mm hexagon wrench.

    3. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.

  2. INSTALL FRONT FENDER APRON SEAL RH

  3. INSTALL ENGINE UNDER COVER RH

  4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

  5. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }