FRONT CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. Apply MP grease to the lip of a new timing chain cover oil seal.

      Note

      Do not allow foreign matter to contact the lip of the timing chain cover oil seal.

    2. A01EYHJE01

      Using SST and a hammer, tap in the timing chain cover oil seal until its surface is flush with the timing chain cover sub-assembly edge.

      SST
      09223-22010

      Note


      • Keep the lip of the timing chain cover oil seal free from foreign matter.

      • Do not tap in the timing chain cover oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. Align the pulley set key with the key groove of the crankshaft pulley.

    2. A01EXP1E01
      Text in Illustration
      *a Hold
      *b Turn

      Using SST, hold the crankshaft pulley and install the pulley bolt.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021
      Torque:
      180 N*m  { 1835 kgf*cm, 132 ft.*lbf }

  3. INSTALL V-RIBBED BELT


    1. A01EVOGE01
      Text in Illustration
      *1 V-ribbed Belt Tensioner Assembly
      *2 Generator
      *3 Water Pump
      *4 Cooler Compressor
      *5 Crankshaft
      *6 Idler

      Set the V-ribbed belt onto each part as shown in the illustration.

    2. Using SST, slowly turn the V-ribbed belt tensioner assembly clockwise and install the V-ribbed belt.

      SST
      09216-42010

      Note


      • Make sure that SST and other tools are set to the V-ribbed belt tensioner assembly securely.

      • When compressing the V-ribbed belt tensioner assembly, slowly turn the V-ribbed belt tensioner assembly.

  4. INSTALL FRONT FENDER APRON SEAL RH

  5. INSTALL ENGINE UNDER COVER RH

  6. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

  7. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }