REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new rear engine oil seal.

      Note

      Do not allow foreign matter to contact the lip of the rear engine oil seal.

    2. A01EVXME01

      Using SST and a hammer, tap in the rear engine oil seal until its surface is flush with the edges of the cylinder block and crankcase.

      SST
      09223-15030
      09950-70010   ( 09951-07100 )

      Note


      • Keep the lip of the rear engine oil seal free from foreign matter.

      • Do not tap in the rear engine oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01ESX4E01

      Using SST, hold the crankshaft.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021

    2. Clean the bolts and their installation holes.

    3. A01ETNA

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. A01EWCWE01
      Text in Illustration
      *1 Drive Plate And Ring Gear Sub-assembly
      *2 Rear Drive Plate Spacer
      A01EUL1 Transaxle Side

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.

    5. A01ET13E03
      Text in Illustration
      *1 Adhesive

      Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A01EW0YE02

      Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

      Torque:
      98 N*m  { 999 kgf*cm, 72 ft.*lbf }

      Note

      Do not start the engine for at least an hour after installing the drive plate and ring gear sub-assembly.

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    Click here