DRIVE BELT INSTALLATION


  1. INSTALL V-RIBBED BELT


    1. A01EYL5E02
      Text in Illustration
      *1 Crankshaft
      *2 Tensioner
      *3 Generator
      *4 Water Pump
      *5 Cooler Compressor

      Set the V-ribbed belt onto each part as shown in the illustration except the water pump pulley.

    2. Loosen the V-ribbed belt by turning the belt tensioner clockwise.

    3. Set the V-ribbed belt onto the water pump pulley.

      Note

      Make sure that the belt is attached to each pulley. In particular, make sure that the belt is securely fitted into the grooves of the crankshaft pulley.

  2. INSTALL FRONT FENDER APRON SEAL RH

  3. INSTALL ENGINE UNDER COVER RH

  4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

  5. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }