ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. DRAIN ENGINE COOLANT

    Note

    Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. Loosen the radiator drain cock plug.

    2. Loosen the cylinder block drain cock plug.

    3. Remove the radiator cap sub-assembly.

      A01EUUEE01
      Text in Illustration
      *1 Radiator Cap Sub-assembly *2 Radiator Drain Cock Plug
      *3 Cylinder Block Drain Cock Plug -

      Tech Tips

      Collect the engine coolant in a container and dispose of it according to the regulations in your area.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01EX2B

      Remove the 9 clips and cool air intake duct seal.

  3. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A01EVXG

      Remove the 2 bolts and inlet air cleaner assembly.

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01EV7D

      Disconnect the vacuum switching valve connector.

    2. Disconnect the 2 vacuum switching valve vacuum hoses.

    3. Disconnect the purge line hose from the 2 clamps.

    4. Disconnect the mass air flow meter connector.

    5. Disconnect the wire harness clamp.

    6. Loosen the 2 bolts and separate the air cleaner cap sub-assembly.

    7. A01EW34

      Disconnect the ventilation hose from the cylinder head cover sub-assembly.

    8. A01EX2PE01
      Text in Illustration
      *1 Air Cleaner Hose Clamp

      Lock the air cleaner hose clamp as shown in the illustration, and disconnect the air cleaner cap sub-assembly from the throttle with motor body assembly.

    9. Remove the air cleaner filter element from the air cleaner case sub-assembly.

  5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01ESTN

      Disconnect the wire harness clamp.

    2. Remove the 3 bolts and air cleaner case sub-assembly.

  7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A01EYB7

      Disconnect the engine coolant temperature sensor connector.

    2. A01EUH6E01
      Text in Illustration
      *1 Ball Joint Lock Nut Wrench
      *2 Gasket

      Using a 19 mm ball joint lock nut wrench, remove the engine coolant temperature sensor.

    3. Remove the gasket from the engine coolant temperature sensor.