SFI SYSTEM PRECAUTION


  1. INITIALIZATION

    Note


    • If the ECM is replaced, register the ECU communication ID for Engine Immobiliser System (Refer to the Service Bulletin for Registration).

    • Make sure to perform Reset Memory (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM Click here.

    • Perform initialization (throttle position) after replacing the throttle with motor body assembly or cleaning any throttle body components Click here.

    • Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM Click here.

    • When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

      System Name See Procedure
      Parking Assist Monitor System

      Click here

    Tech Tips

    Initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.

  2. WHEN USING INTELLIGENT TESTER

    CAUTION:

    Observe the following items for safety reasons:


    • Before using the tester, read the instruction manual.

    • Prevent the tester cable from being caught on the pedals, shift lever or steering wheel when driving with the tester connected to the vehicle.

    • When driving the vehicle for testing purposes using the tester, 2 persons are required. One is for driving the vehicle, and the other operates the tester.