THROTTLE BODY REMOVAL


  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

  3. REMOVE ENGINE UNDER COVER LH

  4. REMOVE ENGINE UNDER COVER RH

  5. DRAIN ENGINE COOLANT

    Note

    Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. Loosen the radiator drain cock plug.

    2. Remove the radiator cap sub-assembly.

      A01ESW1E01
      Text in Illustration
      *1 Radiator Cap Sub-assembly *2 Radiator Drain Cock Plug

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

  6. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01EWTR

      Lift the rear of the engine cover to detach the cover from the 2 pins, and then lift the front of the engine cover to detach the cover from the pin and remove the engine cover.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    1. A01EWQF

      Disconnect the vacuum switching valve assembly from the air cleaner hose.

    2. A01EXPW

      Disconnect the mass air flow meter connector and 2 wire harness clamps from the air cleaner cap sub-assembly.

    3. A01ETVQ

      Separate the fuel vapor feed hose from the air cleaner hose.

    4. A01EWXN

      Disconnect the ventilation hose from the cylinder head cover.

    5. A01EYB6

      Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.

    6. A01EWV3

      Release the 2 clamps and remove the air cleaner cap sub-assembly.

  8. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY


    1. A01EV3P

      Disconnect the fuel tube from the clamp.

    2. Disconnect the throttle body connector.

    3. A01EV92

      Disconnect the water by-pass hose from the throttle with motor body assembly.

    4. Disconnect the No. 2 water by-pass hose from the throttle with motor body assembly.

    5. A01EXJU

      Remove the 4 bolts and the throttle body with fuel tube bracket.

    6. A01EX78

      Remove the bolt and fuel tube bracket.

    7. A01EVVQ

      Remove the gasket from the intake manifold.