FUEL PUMP REASSEMBLY


  1. INSTALL FUEL PUMP


    1. A01EVWEE04
      Text in Illustration
      *1 O-ring
      *2 Fuel Pump Spacer

      Apply gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump.

    2. A01EVE3E01
      Text in Illustration
      *1 Fuel Filter
      *2 Suction Filter

      Engage the 5 claws on the fuel filter and install the fuel pump with the suction filter.

      Note


      • Make sure that the O-ring is not cut or pinched during the installation.

      • Engage the claws securely.

      • Do not remove the suction filter.

      Tech Tips

      Perform "Inspection After Repair" after replacing the fuel pump Click here.

  2. INSTALL NO. 1 FUEL SUCTION SUPPORT


    1. A01EUMO

      Engage the 2 claws of the No. 1 fuel suction support.

  3. INSTALL LOWER FUEL TANK CASE SUB-ASSEMBLY


    1. Connect the fuel pump harness connector to the fuel pump.

    2. Install the spring to the fuel suction plate shaft and install it to the lower fuel tank case sub-assembly.

    3. A01EU8V

      Engage the 4 claws of the No. 1 fuel suction support and install the lower fuel tank case sub-assembly to the fuel suction plate with the fuel filter.

    4. Install a new E-ring.

    5. Connect the fuel pump harness connectors to the fuel suction plate.

  4. INSTALL FUEL SENDER GAUGE ASSEMBLY


    1. A01ET3E

      Slide the fuel sender gauge to fit the claw.

    2. Connect the connector of the fuel sender gauge assembly.