РЕГУЛЯТОР ДАВЛЕНИЯ В ТОПЛИВНОЙ СИСТЕМЕ СНЯТИЕ


  1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

    Click here

  2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. A003V5R

      Отсоедините 3 зажима жгута проводов.

      Note

      Будьте осторожны, чтобы не повредить жгут проводов.

    2. A003YAT

      Снимите 2 защиты со жгута проводов.

      Note

      Будьте осторожны, чтобы не повредить жгут проводов.

    3. A003XQT

      Отсоедините разъем датчика уровня топлива в сборе.

    4. A003W7C

      Освободите замок, как показано на рисунке, и сдвиньте датчик уровня топлива в сборе, чтобы снять его.

  3. REMOVE FUEL PUMP


    1. A003ZFZ

      Disconnect the connector of the fuel pump harness.

    2. A003VWY

      Disconnect the fuel pump filter hose.

    3. A003WDAE02
      Text in Illustration
      *1 Fuel Tube
      *2 Fuel Sub-tank

      Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws, and remove the fuel filter and fuel pump from the fuel sub-tank.

      Note

      Do not do anything which may separate the fuel tube from either the fuel suction plate or fuel filter assembly, such as applying excessive force to the tube Click here.

    4. A003W1K

      Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.

    5. A003X75E01
      Text in Illustration
      *1 Fuel Filter
      *2 Suction Filter

      Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws, and remove the fuel pump from the fuel filter.

      Note


      • Do not damage the fuel filter.

      • Do not remove the suction filter.

      • Do not use either the fuel pump or the suction filter if the suction filter is removed from the fuel pump.

    6. A003V8L

      Disconnect the fuel pump harness connector.

    7. A003W9FE06
      Text in Illustration
      *1 O-ring
      *2 Spacer
      *a 5.0 mm (0.197 in.)

      Remove the O-ring and spacer from the fuel pump.

      Note

      Be careful not to damage the sealing surface.

      Tech Tips

      If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm diameter) that is formed as shown in the illustration.

  4. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    1. A003XMW

      Using a screwdriver with its tip wrapped in protective tape, remove the fuel pressure regulator assembly.

      Note

      Slowly pull out the fuel pressure regulator assembly because the O-ring is firmly installed between the regulator and the fuel filter.

    2. A003YDHE11
      Text in Illustration
      *1 O-ring

      Remove the 2 O-rings from the pressure regulator assembly.