POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips

Use the same procedure for RH side and LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE REAR DOOR UPPER ARMREST BASE PANEL ASSEMBLY

    Click here

  4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  5. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  6. REMOVE REAR DOOR GLASS RUN

    Click here

  7. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

    Click here

  8. REMOVE REAR DOOR REAR GUIDE SEAL

    Click here

  9. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  10. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

    Click here

  11. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY

    A005LLT

    1. Using a T25 "TORX" socket wrench, remove the 3 screws and the front power window regulator motor assembly.