POWER WINDOW REGULATOR MOTOR(for Front Door) INSTALLATION

PROCEDURE

1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

   
   

   1. Using a T25 "TORX" driver, install the front power window regulator motor assembly RH with the 3 screws.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Tech Tips

      A new front window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

   Click here

3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

   Click here

4. INSTALL FRONT DOOR SERVICE HOLE COVER

   Click here

5. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

   Click here

6. INSTALL FRONT UPPER ARMREST BASE PANEL ASSEMBLY

   Click here

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Torque:

   5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

8. INITIALIZE POWER WINDOW CONTROL SYSTEM

   Click here