POWER WINDOW REGULATOR MOTOR(for Front Door) INSPECTION

PROCEDURE


  1. INSPECT FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (for Driver Side)

    Note


    • Do not apply positive (+) battery voltage to any terminals other than terminal 1, 2, 4, 7 and 10 to avoid damaging the pulse sensor inside the motor.

    • When a power window regulator or a power window regulator motor assembly is replaced, the power window control system must be initialized Click here.


    1. Apply battery voltage to the motor connector according to the table below.

      A005IYVE03
      Text in Illustration
      *A for LHD *B for RHD
      *1 Motor Gear - -
      *a Counterclockwise *b Clockwise
      *c

      Component without harness connected

      (Power Window Regulator Motor (Driver Side))

      		 - -

      Note

      Do not apply battery voltage to any terminals except terminals 1, 2, 4, 7 and 10.

      OK
      Switch Condition Measurement Condition Specified Condition
      Manual Operation

      Battery positive (+) → Terminal 2 (B)

      Battery negative (-) → Terminal 1 (E), 7 (DWN1)

      		 Motor gear rotates counterclockwise

      Battery positive (+) → Terminal 2 (B)

      Battery negative (-) → Terminal 1 (E), 10 (UP1)

      		 Motor gear rotates clockwise
      Auto Operation

      Battery positive (+) → Terminal 2 (B)

      Battery negative (-) → Terminal 1 (E), 4 (AUTO), 7 (DWN1)

      		 Motor gear rotates counterclockwise

      Battery positive (+) → Terminal 2 (B)

      Battery negative (-) → Terminal 1 (E), 4 (AUTO), 10 (UP1)

      		 Motor gear rotates clockwise

      If the result is not as specified, replace the regulator motor assembly.

  2. INSPECT FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (for Front Passenger Side)

    Note


    • Do not apply positive (+) battery voltage to any terminals other than terminals 1 and 2 to avoid damaging the pulse sensor inside the motor.

    • When a power window regulator or a power window regulator motor assembly is replaced, the power window control system must be initialized Click here.


    1. Apply battery voltage to the motor connector according to the table below.

      A005KE9E04
      Text in Illustration
      *A for LHD *B for RHD
      *1 Motor Gear - -
      *a Counterclockwise *b Clockwise
      *c

      Component without harness connected

      (Power Window Regulator Motor (Front Passenger Side))

      		 - -

    2. Check that the motor gear rotates smoothly as follows.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → 1

      Battery negative (-) → 2

      		 Motor gear rotates clockwise

      Battery positive (+) → 2

      Battery negative (-) → 1

      		 Motor gear rotates counterclockwise

      If the result is not as specified, replace the regulator motor assembly.