FRONT EVAPORATOR TEMPERATURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 COOLER THERMISTOR


    1. A005HB6E06
      Text in Illustration
      *1 Plastic Case
      *2 Evaporator
      *a from Tank
      *b Fixed Part
      *c Sensor Part
      *d Next to Previous

      Install No. 1 cooler thermistor as shown in the illustration.

      Installation Position
      Mark Measurement
      a 34.3 mm (1.35 in.)
      b 20.9 mm (0.82 in.)
      c 48 to 52 mm (1.890 to 2.047 in.)

      Note


      • Be sure to insert the sensor only once because reinserting it will not allow it to be firmly secured.

      • When reusing the evaporator, insert the sensor one row next to the one that was used previously (*d in the illustration).

      • After inserting the sensor, do not apply excessive force to the wire.

      • Directly insert the sensor until the edge of the plastic case "*1" comes into contact with the evaporator "*2".

  2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

    Click here

  3. INSTALL COOLER EXPANSION VALVE

    Click here

  4. INSTALL AIR CONDITIONING RADIATOR ASSEMBLY

    Click here