CONDENSER(for 1NZ-FE) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  4. REMOVE FRONT BUMPER COVER

    Click here

  5. REMOVE HEADLIGHT ASSEMBLY

    Click here

  6. REMOVE NO. 1 COOLER COVER

    Click here

  7. REMOVE AIRBAG SENSOR BRACKET

    Click here

  8. REMOVE HOOD LOCK ASSEMBLY

    Click here

  9. REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY

    Click here

  10. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

    A005GTL

    1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the cooler condenser assembly.

    2. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.

  11. DISCONNECT LIQUID TUBE SUB-ASSEMBLY


    1. A005KXD

      Remove the bolt and disconnect the liquid tube sub-assembly from the cooler condenser assembly.

    2. Remove the O-ring from the liquid tube sub-assembly.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.

  12. REMOVE COOLER CONDENSER ASSEMBLY

    A005LQZ

    1. Disengage the 2 claws and 2 guides and remove the cooler condenser assembly from the vehicle.

      Note

      Do not damage the cooler condenser assembly or radiator assembly when removing the cooler condenser assembly.