COMBUSTION TYPE POWER HEATER SYSTEM, Diagnostic DTC:052

DTC Code DTC Name
052 Safety Time Exceeded

DESCRIPTION

DTC No. DTC Detection Condition Trouble Area
052 A heater ignition failure is detected.

  • Air duct

  • Exhaust pipe

  • Heater fuel pump sub-assembly

  • Fuel pump filter (heater fuel pump sub-assembly)

  • Power heater ECU (combustion heater assembly)

CAUTION / NOTICE / HINT

CAUTION:


  • In some cases, the combustion heater, air duct and exhaust pipe are extremely hot. When performing the inspection, wear protective gloves and do not touch these parts with bare hands.

  • When performing the inspection, wear a face mask to prevent direct inhalation of exhaust gas.

PROCEDURE


  1. INSPECT FUEL PIPE


    1. Check that there is no fuel leakage between heater fuel pump sub-assembly and combustion heater assembly.

      Result
      Result Proceed to
      There is no problem in the fuel pipe. A
      There is a problem in the fuel pipe. B

    B

    REPAIR OR REPLACE FUEL PIPE

    A

  2. INSPECT AIR DUCT


    1. Perform the following checks for the air duct.


      • The air duct is not clogged with foreign matter.

      • Air intake is normal.

      • The air duct is correctly installed to the combustion heater assembly.

      • There are no defects that would cause air to leak from the intake air duct.

      Result
      Result Proceed to
      There is no problem with the air duct. A
      There is a problem with the air duct. B

    B

    CLEAN OR REPLACE AIR DUCT Click here

    A

  3. INSPECT EXHAUST PIPE


    1. Perform the following checks for the exhaust air duct.


      • The exhaust pipe is not clogged with foreign matter.

      • Air exhaust is normal.

      • The exhaust pipe is correctly installed to the combustion heater assembly.

      • There are no defects that would cause air to leak from the exhaust pipe.

      Result
      Result Proceed to
      There is no problem with the exhaust pipe A
      There is a problem with the exhaust pipe B

    B

    CLEAN OR REPLACE EXHAUST PIPE Click here

    A

  4. INSPECT HEATER FUEL PUMP SUB-ASSEMBLY


    1. A005IGRE09
      Text in Illustration
      *a

      Component without harness connected

      (Heater pump assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A30-1 (+B) - A30-2 (E2) Always 9 to 12 Ω

    2. Inspect heater fuel pump sub-assembly operation.


      1. Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, and check the pressure of the hose by hand.

        CAUTION:


        • This inspection must be done quickly (within 10 seconds) to prevent damage to the heater fuel pump sub-assembly.

        • Always switch the voltage on and off on the battery side, not the heater fuel pump sub-assembly side.

        • Keep the heater fuel pump sub-assembly as far away from the battery as possible.

        OK
        Pressure is applied to the hose.

    NG

    REPLACE HEATER FUEL PUMP SUB-ASSEMBLY Click here

    OK

  5. REPLACE FUEL PUMP FILTER (HEATER FUEL PUMP SUB-ASSEMBLY)


    1. Replace the fuel pump filter (heater fuel pump sub-assembly) with a new one Click here.

    2. Check that the condition returns to normal.

      OK
      The combustion heater assembly is ignited normally and it starts operating.

    OK

    END (FUEL PUMP FILTER IS FAULTY)

    NG

    REPLACE COMBUSTION HEATER ASSEMBLY Click here