FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    1. A005KWLE04
      Text in Illustration
      *a Unlock
      *b 45 °
      *c Lock

      Check the angle of inclination required to lock the retractor.


      1. Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15 ° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45 ° or more.

        Note

        Do not disassemble the retractor.

        If the operation is not as specified, replace the front seat outer belt.

    2. A005J2YE01

      Hook the lower stay of the retractor onto the 2 body hooks and temporarily install the front seat outer belt assembly with the 2 bolts.

    3. Tighten bolt A and then bolt B.

      Torque:
      4.9 N*m  { 50 kgf*cm, 43 in.*lbf }
      for bolt A
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
      for bolt B
    4. A005HQIE01

      Connect the pretensioner connector.

    5. Lock the locking button.

      Text in Illustration
      *1 Locking Button

      Note

      Securely lock the locking button.

    6. Install the shoulder anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  2. INSTALL CENTER PILLAR UPPER GARNISH

    Click here

  3. CONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. Install the floor anchor with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    2. Check that the ELR locks.

      Note


      • The check should be performed with the front seat outer belt installed.

      • Do not allow the anchor part of the front seat outer belt and the protruding parts of the floor panel to overlap.


      1. With the belt installed, check that the belt locks when it is pulled out quickly. If the operation is not as specified, replace the front seat outer belt assembly.

  4. INSTALL LAP BELT OUTER ANCHOR COVER


    1. Engage the 3 claws and install the lap belt outer anchor cover.

  5. INSTALL CENTER PILLAR LOWER GARNISH

    Click here

  6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

    Click here

  7. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

    Click here

  8. INSTALL REAR DOOR SCUFF PLATE

    Click here

  9. INSTALL FRONT DOOR SCUFF PLATE

    Click here

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  11. INSPECT SRS WARNING LIGHT

    Click here