FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

Tech Tips

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

  3. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  4. REMOVE REAR DOOR SCUFF PLATE

    Click here

  5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP

    Click here

  6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP

    Click here

  7. REMOVE CENTER PILLAR LOWER GARNISH

    Click here

  8. REMOVE LAP BELT OUTER ANCHOR COVER


    1. A005L3A

      Disengage the 3 claws and remove the lap belt outer anchor cover.

  9. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A005GR0

      Remove the bolt and disconnect the floor anchor.

  10. REMOVE CENTER PILLAR UPPER GARNISH

    Click here

  11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A005M2W

      Remove the bolt and the shoulder anchor.

    2. A005HCFE03

      Using a screwdriver with its tip wrapped in protective tape, release the locking button.

    3. Using a screwdriver with its tip wrapped in protective tape, disconnect the pretensioner connector.

      Text in Illustration
      *1 Protective Tape
      *2 Locking Button
    4. A005HFN

      Remove the 2 bolts.

    5. Disengage the 2 hooks and remove the front seat outer belt assembly.