FRONT SEAT INNER BELT ASSEMBLY(for Driver Side) REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    Tech Tips


    • Use the same procedure for RHD and LHD vehicles.

    • The procedure listed below is for LHD vehicles.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE FRONT SEAT ASSEMBLY

    Click here

  4. REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/o Seat Heater System)


    1. A005GF2

      Disengage the 4 clamps.

    2. A005J67

      Remove the wire harness from the claw of the front seat cushion shield.

    3. Remove the bolt and the front seat inner belt assembly.

  5. REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/ Seat Heater System)


    1. A005GYV

      Disengage the 5 clamps.

    2. Disconnect the seat heater connector.

    3. A005J67

      Remove the wire harness from the claw of the front seat cushion shield.

    4. Remove the bolt and the front seat inner belt assembly.