OCCUPANT DETECTION SENSOR REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    Tech Tips


    • Use the same procedure for RHD and LHD vehicles.

    • The procedure listed below is for LHD vehicles.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE FRONT SEAT HEADREST ASSEMBLY

    Click here

  4. REMOVE FRONT SEAT REAR OUTER TRACK COVER

    Click here

  5. REMOVE FRONT SEAT ASSEMBLY

    Click here

  6. REMOVE SEAT ADJUSTER COVER CAP

    Click here

  7. REMOVE RECLINING ADJUSTER RELEASE HANDLE

    Click here

  8. REMOVE FRONT SEAT CUSHION SHIELD

    Click here

  9. REMOVE FRONT SEAT CUSHION INNER SHIELD

    Click here

  10. REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/ Seat Heater System)

    Click here

  11. REMOVE FRONT SEAT INNER BELT ASSEMBLY (w/o Seat Heater System)

    Click here

  12. REMOVE FRONT SEAT CUSHION COVER WITH PAD (OCCUPANT DETECTION SENSOR)

    Click here

  13. REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD (OCCUPANT DETECTION SENSOR) (for Leather Seat)


    1. A005HMK

      Remove the 16 hog rings and separate type front seat cushion pad (occupant detection sensor) from the separate type front seat cushion cover.