CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.
Tech Tips
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
PROCEDURE
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
DISCONNECT BATTERY NEGATIVE TERMINAL
REMOVE FRONT SEAT HEADREST ASSEMBLY
Press the headrest support button and pull up the front seat headrest assembly.
REMOVE FRONT SEAT REAR OUTER TRACK COVER
Disengage the 2 claws and guide, remove the front seat rear outer track cover.
REMOVE FRONT SEAT ASSEMBLY
Lift up the seat track adjusting handle and move the seat to the rearmost position.
Using "TORX" socket wrench E10, remove the 2 bolts on the front side of the seat.
Lift up the seat track adjusting handle and move the seat to the foremost position.
Using "TORX" socket wrench E10, remove the 2 bolts on the rear side of the seat.
Lift up the seat track adjusting handle and move the seat to the center position.
Also, operate the reclining adjuster release handle and move the seatback to the upright position.
Detach the 2 location pins, remove the front seat assembly from the vehicle.
Note
Be careful not to damage the vehicle body.
REMOVE FRONT DOOR SCUFF PLATE
REMOVE COWL SIDE TRIM BOARD
REMOVE REAR CONSOLE BOX ASSEMBLY
REMOVE NO. 1 METER HOOD CLUSTER
REMOVE NO. 2 METER HOOD CLUSTER
REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
REMOVE LOWER INSTRUMENT PANEL CENTER FINISH PANEL
REMOVE FRONT SEAT REAR LOWER INNER TRACK BRACKET
Remove the 4 bolts and front seat rear lower inner track bracket.