FRONT AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. INSTALL FRONT AIRBAG SENSOR

    Note


    • Do not use the front airbag sensor that has been dropped.

    • Do not subject the front airbag sensor to any impact or force.


    1. Confirm that the ignition switch is turned off.

    2. Confirm that the cable is disconnected from the negative battery terminal.

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • Confirm that the cable is disconnected from the negative battery terminal before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

    3. Insert the hook into the body hole and install the front airbag sensor to the vehicle with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

    4. Connect the front airbag sensor connector.

    5. Confirm that there is no looseness by shaking the front airbag sensor.

  2. INSTALL AIRBAG SENSOR BRACKET


    1. Install the airbag sensor bracket with the 2 bolts.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

  3. INSTALL FRONT BUMPER COVER

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  5. INSPECT SRS WARNING LIGHT

    Click here