FRONT PASSENGER AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  4. REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL WIRE

    A005JSPE02
    Text in illustration
    *1 Locking Button
    *2 Protective Tape

    1. Disengage the clamp.

    2. Using a thin-bladed screwdriver with its tip wrapped with protective tape, release the locking button.

    3. Using a thin-bladed screwdriver with its tip wrapped with protective tape, disconnect the airbag connector and remove the No. 2 instrument panel wire.

  6. REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

    A005L2P

    1. Remove the 2 screws.

    2. A005K9PE01

      Disengage the 3 hooks A.

    3. Disengage the 3 hooks B and remove the instrument panel passenger airbag assembly as shown in the illustration .