SPIRAL CABLE INSPECTION

PROCEDURE


  1. INSPECT SPIRAL CABLE SUB-ASSEMBLY

    Note


    • Do not remove the steering sensor from the spiral cable sub-assembly (w/ VSC).

    • If there is a malfunction in the steering sensor, replace the spiral cable sub-assembly with steering sensor (w/ VSC).


    1. If there are any defects as mentioned below, replace the spiral cable sub-assembly with a new one:


      • Scratches, cracks, dents or chips on the connector or the spiral cable sub-assembly.

    2. A005HSPE02

      Inspect the spiral cable sub-assembly.


      1. Measure the resistance according to the value(s) in the table below.

        Note

        To avoid breaking the spiral cable sub-assembly, do not turn the spiral cable sub-assembly more than necessary.

        Standard Resistance
        Tester Connection Condition Specified Condition

        F5-8 - z2-1

        (HO)

        		 Always Below 1Ω

        F5-8 - z3-2

        (HO)

        		 Always Below 1Ω

        F5-9 - z2-2

        (SUP)

        		 Always Below 1Ω

        F5-10 - z2-3

        (SDN)

        		 Always Below 1Ω

        F5-4 - z2-8

        (EAU)

        		 Always Below 1Ω

        F5-5 - z2-9

        (AU2)

        		 Always Below 1Ω

        F5-6 - z2-10

        (AU1)

        		 Always Below 1Ω

        F17-1 - z1-2

        (D+)

        		 Always Below 1Ω

        F17-2 - z1-1

        (D-)

        		 Always Below 1Ω
        Text in Illustration
        *a

        Component without harness connected

        (Spiral Cable Sub-assembly)

        If the value is not within the specified range, replace the spiral cable sub-assembly.