REAR AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL NO. 2 SIDE AIRBAG SENSOR ASSEMBLY

   Note

   
   

   • Do not use a No. 2 side airbag sensor assembly that has been dropped.

   • Do not subject the No. 2 side airbag sensor assembly to any impact or force.

   
   

   1. Confirm that the ignition switch is turned off.

   2. Confirm that the negative battery terminal is disconnected.

      CAUTION:

      
      

      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • Confirm that the negative battery terminal is disconnected before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

   3. Insert the hook into the body hole and install the No. 2 side airbag sensor assembly with the bolt.

      Torque:

      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

   4. Connect the No. 2 side airbag sensor assembly connector.

   5. Confirm that there is no looseness by shaking the No. 2 side airbag sensor assembly.

2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY

   Click here

3. INSTALL RECLINING REMOTE CONTROL BEZEL

   Click here

4. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY

   Click here

5. INSTALL DECK SIDE TRIM BOX (w/o Rear Deck Floor Box)

   Click here

6. INSTALL LUGGAGE ROOM BOX SEPARATOR

   Click here

7. INSTALL REAR FLOOR REAR MAT (w/o Rear Deck Floor Box)

   Click here

8. INSTALL REAR DECK TRIM COVER

   Click here

9. INSTALL BACK DOOR WEATHERSTRIP

   Click here

10. INSTALL REAR DECK FLOOR BOX (w/ Rear Deck Floor Box)

    Click here

11. INSTALL DECK BOARD ASSEMBLY

    Click here

12. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

    Click here

13. INSTALL REAR DOOR SCUFF PLATE

    Click here

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:

    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

15. INSPECT SRS WARNING LIGHT

    Click here