REAR AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  3. REMOVE REAR DOOR SCUFF PLATE

    Click here

  4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP

    Click here

  5. REMOVE DECK BOARD ASSEMBLY

    Click here

  6. REMOVE REAR DECK FLOOR BOX (w/ Rear Deck Floor Box)

    Click here

  7. REMOVE BACK DOOR WEATHERSTRIP

    Click here

  8. REMOVE REAR DECK TRIM COVER

    Click here

  9. REMOVE REAR FLOOR REAR MAT (w/o Rear Deck Floor Box)

    Click here

  10. REMOVE LUGGAGE ROOM BOX SEPARATOR

    Click here

  11. REMOVE DECK SIDE TRIM BOX (w/o Rear Deck Floor Box)

    Click here

  12. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY

    Click here

  13. REMOVE RECLINING REMOTE CONTROL BEZEL

    Click here

  14. REMOVE DECK TRIM SIDE PANEL ASSEMBLY

    Click here

  15. REMOVE NO. 2 SIDE AIRBAG SENSOR ASSEMBLY

    A005IMP

    1. Confirm that the ignition switch is turned off.

    2. Confirm that the cable is disconnected from the negative battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Disconnect the No. 2 side airbag sensor assembly connector.

      Note

      Do not disconnect the No. 2 side airbag sensor assembly connector by pulling the wire harness.

    4. Remove the bolt and the No. 2 side airbag sensor assembly.