REAR AIRBAG SENSOR ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT NO. 2 SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision)

   
   

   1. Perform a diagnostic system check Click here.

2. INSPECT NO. 2 SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)

   
   

   1. Perform a diagnostic system check Click here.

   2. When the rear pillar of the vehicle or its periphery is damaged, check whether there is any damage to the No. 2 side airbag sensor assembly. If there are any defects, such as those mentioned below, replace the No. 2 side airbag sensor assembly with a new one:

      
      

      • Any cracks, dents or chips in the case.

      • Any cracks or other damage to the connector.

      • Peeling of the label or damage to the serial number.

        CAUTION:

        For removal and installation of the No. 2 side airbag sensor assembly, be sure to follow the correct procedure.

3. INSPECT NO. 2 SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle Involved in Collision and Airbag Deployed)

   
   

   1. When airbags have deployed as the result of a collision, be certain to replace all airbag sensors in the damaged area (anywhere in need of repair). Furthermore, it is also necessary to replace any airbag sensor in undamaged areas that have registered a major collision, or which exhibits any of the following abnormalities:

      
      

      • Any cracks, dents or chips in the case.

      • Any cracks or other damage to the connector.

      • Peeling of the label or damage to the serial number.

        CAUTION:

        For removal and installation of the No. 2 side airbag sensor assembly, be sure to follow the correct procedure.