SIDE AIRBAG SENSOR INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

PROCEDURE


  1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY

    Note


    • Do not use a side airbag sensor that has been dropped.

    • Do not subject the side airbag sensor to any impact or force.


    1. Confirm that the ignition switch is turned off.

    2. Confirm that the cable is disconnected from the negative battery terminal.

      CAUTION:


      • Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      • Confirm that the cable is disconnected from the negative battery terminal before performing the operation. Even an impact to only the airbag sensor will cause the airbag to deploy.

    3. Insert the hook into the body hole and install the side airbag sensor assembly with the bolt.

      Torque:
      9.0 N*m  { 92 kgf*cm, 80 in.*lbf }

    4. Confirm that there is no looseness by shaking the side airbag sensor assembly.

    5. Connect the side airbag sensor assembly connector.

  2. INSTALL CENTER PILLAR LOWER GARNISH

    Click here

  3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

    Click here

  4. INSTALL REAR DOOR SCUFF PLATE

    Click here

  5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

    Click here

  6. INSTALL FRONT DOOR SCUFF PLATE

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  8. INSPECT SRS WARNING LIGHT

    Click here